消防水带正确的使用方法有哪些？

来源：http://www.cx-fire.com/ 日期：2023-12-25

消防水带是用来运送高压水或泡沫等阻燃液体的软管。传统的消防水带以橡胶为内衬，外表面包裹看亚麻编织物。的消防水带则用聚氨酯等聚合材料制成。消防水带的两头都有金属接头，可以接上另一根水带以延长距离或是接上喷嘴以增大液体喷压力。

Fire hose is used to transport high-pressure water or foam and other flame retardant liquids. Traditional fire hoses are lined with rubber and wrapped in linen woven fabric on the outside. Advanced fire hoses are made of polymer materials such as polyurethane. Both ends of the fire hose have metal joints, which can be connected to another hose to extend the distance or to a nozzle to increase the liquid spray pressure.

型65-25米 消防水带

Type 65-25 meter fire hose

消防水带正确的使用方法

Correct usage of fire hoses

打开防火栓门，取出水龙带水枪。

Open the fire hydrant door and remove the hose and water gun.

检查水带及接头是否良好，如有破损严禁使用。

Check if the water hose and joints are in good condition. If there is any damage, it is strictly prohibited to use.

向火场方向铺设水带，避免扭折。

Lay water hoses in the direction of the fire to avoid twisting and folding.

将水带靠近消火栓端与消火栓连接，连接时将连接扣准确插入滑槽，按顺时针方向拧紧。

Connect the water hose close to the end of the fire hydrant and connect it to the fire hydrant. When connecting, insert the connecting buckle accurately into the sliding groove and tighten it clockwise.

将水带另一端与水枪连接(连接程序与消火栓连接相同)。

Connect the other end of the hose to the water gun (the connection procedure is the same as that of the fire hydrant).

连接完毕后，少有2人握紧水枪，对准火场(勿对人，防止高压水伤人)。

After the connection is completed, at least 2 people should hold the water gun tightly and aim it at the fire scene (do not face people to prevent high-pressure water from injuring people).

缓慢打开消火栓阀门，对准火场根部进行灭火。

Slowly open the fire hydrant valve to the maximum and aim at the root of the fire to extinguish the fire.

消防水带连接，消防消防水带在套上消防水带接口时，须垫上一层柔软的保护物，然后用镀锌铁丝或喉箍扎紧。

Fire hose connection: When the fire hose is connected to the fire hose interface, a layer of soft protective material must be placed on it, and then it should be tied tightly with galvanized iron wire or hose clamps.

消防水带的使用。使用消防消防水带时，应将耐高压的消防水带接在离水泵较近的地方，充水后的消防水带应防止扭转或骤然折弯，同时应防止消防水带接口碰撞损坏。

The use of fire hoses. When using fire hoses, high-pressure resistant fire hoses should be connected closer to the water pump. The filled fire hose should be prevented from twisting or suddenly bending, and the fire hose interface should be prevented from collision and damage.

消防水带铺设。铺设消防水带时，要避开夹锐物体和各种油类，向高处垂直铺设消防水带时，要利用消防水带挂钩，通过交通要道铺设消防水带时，应垫上消防水带护桥，通过铁路时，消防水带应从轨道下面通过，避免消防水带被车轮碾坏而间断供水。

Fire hose laying. When laying fire hoses, avoid sharp objects and various oils. When laying fire hoses vertically upwards, use fire hose hooks. When laying fire hoses through traffic arteries, a fire hose protection bridge should be placed. When passing through railways, fire hoses should pass under the track to avoid being crushed by wheels and interrupting water supply.

防止结冰。严冬季节，在火场上需暂停供水时，为防止消防水带结冰，水泵需慢速运转， 保持较小的出水量。

Prevent icing. In the harsh winter season, when water supply needs to be suspended on a fire site, in order to prevent the fire hose from freezing, the water pump needs to run slowly to maintain a small water output.

消防水带清洗，消防水带使用后，要清洗干净，对输送泡沫的消防水带，必须细致的洗刷，保护胶层。为了消防水带上的油脂，可用温水或肥皂洗刷，对冻结的消防水带，要使用之融化，然后清洗晾干没有晾干的消防水带不应收卷存放。

The fire hose shall be cleaned after use. The fire hose conveying foam must be carefully washed to protect the adhesive layer. To remove grease from fire hoses, warm water or soap can be used to wash them. For frozen fire hoses, they should be melted first, and then cleaned and dried. Fire hoses that have not been dried should not be stored in rolls.

感谢您的阅读，此文的文章来源：川消更多的内容和问题请点击：http://www.cx-fire.com我们会继续努力的为您提供服务，感谢您的支持！

Thank you for reading. The source of this article is Sichuan Consumers. For more information and questions, please click: http://www.cx-fire.com We will continue to work hard to provide you with services. Thank you for your support!