Whether there are obstacles around the construction of fire pump adapter; Whether the water pump adapter is damaged, deformed, rusted and has operation obstacles.

闸阀是否处于开启状态;放水口周围有无放置构成操作障碍的物品。

Whether the gate valve is open; Check whether there are any objects that constitute obstacles to operation around the water outlet.

不同的消防水泵接合器是否有明显标志;单向阀安装方向是否正确。

Whether different fire pump adapters have obvious signs; Check whether the installation direction of the check valve is correct.

每月检查地下式消防水泵接合器阀门井，及时阀门井内的垃圾与杂物，确保消防水泵接合器施工能正常使用。

Check the valve well of the underground fire pump adapter every month, and timely remove the garbage and sundries in the valve well to ensure that the fire pump adapter can be used normally during construction.

消防水泵接合器与墙壁之间的通道是否通畅(墙壁式水泵接合器除外)如有垃圾、杂物，需及时。

Whether the passage between the fire pump adapter and the wall is unobstructed (except for the wall pump adapter). If there are garbage and sundries, they should be removed in time.

检查消防水泵接合器接口及配套附件是否完好，目测有无渗漏，闷盖是否盖好。

Check whether the interface and supporting accessories of the fire pump adapter are intact, whether there is leakage by visual inspection, and whether the blind cover is well covered.

地下式消防水泵接合器标识是否完整，如已被移除，需及时补上。

Whether the identification of underground fire pump adapter is complete. If it has been removed, it needs to be supplemented in time.

检查水泵的密封环磨损情况，必要时更换或修理(检查方法：打开后观察)。

Check the wear of the sealing ring of the water pump and replace or repair it if necessary (inspection method: observe after opening).

更换密封填料、检查所有轴承转动情况，用温感器测温，温度不超过75℃、更换轴承润滑油。

Replace the sealing packing, check the rotation of all bearings, measure the temperature with a temperature sensor, the temperature shall not exceed 75 ℃, and replace the bearing lubricating oil.

检查联轴器与轴的磨损情况，必要时更换轴承或轴;泵叶、泵壳腐蚀情况，泵壳及机座涂防锈漆，如蚀穿或缺损则更换。检查压力表是否正常，对电机做年度检修保养。

Check the wear of coupling and shaft, and replace the bearing or shaft if necessary; Corrosion of pump blade and pump casing. The pump casing and base shall be coated with antirust paint. If it is corroded or damaged, it shall be replaced. Check whether the pressure gauge is normal and conduct annual maintenance for the motor.

以上内容就是今天小编为您介绍的川消http://www.cx-fire.com的相关知识，更多的内容请继续关注我们。

The above content is the Sichuan consumer that Xiaobian introduced to you today http://www.cx-fire.com For more information, please continue to pay attention to us.