在流行期间，公司大多处于恢复工作的初期，这是对自动火灾报警和火灾联动控制系统进行测试和调试的有利时机。公司应检查火灾报警控制器的主菜单，以检查自动火灾报警系统

During the popular period, most companies are in the early stage of resuming work, which is a favorable opportunity to comprehensively test and debug the automatic fire alarm and fire linkage control system. The company shall check the main menu of the fire alarm controller to check the automatic fire alarm system

是否有故障，火灾报警，动作和防护罩。等信息。检查火灾探测与报警系统，火灾联动控制系统，可燃气体探测与报警系统以及电气火灾监控系统的工作状态。

Whether there is fault, fire alarm, action and protective cover. And other information. Check the working status of fire detection and alarm system, fire linkage control system, combustible gas detection and alarm system and electrical fire monitoring system.

消防器材厂家

Fire fighting equipment manufacturer

检查双电源的开关状态，并检查火灾报警控制器主备电源的工作状态。并切断主电源，测试备用电源是否可以正常供电。

Check the switching state of dual power supply and the working state of main and standby power supply of fire alarm controller. Cut off the main power supply and test whether the standby power supply can supply power normally.

还应测试火灾探测器的火灾报警和故障报警功能。手动触发手动报警按钮，检查火灾报警控制器输出的火灾报警信号和手动报警按钮报警确认灯的显示

The fire alarm and fault alarm functions of the fire detector shall also be tested. Manually trigger the manual alarm button and check the fire alarm signal output by the fire alarm controller and the display of the alarm confirmation light of the manual alarm button

灭火系统消防器材公司应检查消防水池，消防水箱和补充水的消防设备的水位是否正常，阀门是否打开，管道是否生锈以及是否存在结露。是接口泄漏。在寒冷地区，检查灭火水是否冻结，防冻措施是否完好有效。

The fire fighting equipment company of the fire extinguishing system shall check whether the water level of the fire pool, fire water tank and fire fighting equipment of make-up water is normal, whether the valve is opened, whether the pipeline is rusted and whether there is condensation. It's an interface leak. In cold areas, check whether the fire extinguishing water is frozen and whether the anti freezing measures are intact and effective.

手动启动稳定泵和消防水泵的主泵和备用泵，以检查泵组是否运行平稳，并手动停止。模拟主泵故障，检查备用泵的自动切换启动，并检查仪器的显示和指示灯。还需要远程自动和手动启动和停止消防控制室中的每个消防水泵，以检查水泵的动作和反馈信号。

Manually start the main pump and standby pump of stabilization pump and fire pump to check whether the pump set operates stably and stop manually. Simulate the failure of the main pump, check the automatic switching start of the standby pump, and check the display and indicator light of the instrument. It is also necessary to remotely start and stop each fire pump in the fire control room automatically and manually to check the action and feedback signal of the water pump.